1968 -1970 RALLEY INSTR. CLUSTER TIC TOC TAC.REPLACE THAT OLD IN-ACCURATE TAC WITH A BRAND NEW ONE. THIS UNIT HOOKS TO FACTORY WIRING LOOKS FACTORY WHEN INSTALLED.WORKS WITH POINTS, ELECTRONIC OR MSD IGNITONS AND HAS A MODERN QUARTS CLOCK MOVEMENT.

THIS IS A REPRODUCTION TACHOMETER FOR THE 71-74 B- BODY DODGE AND PLYMOUTHS WITH RALLEY INSTR. CLUSTERS. HAS ALL MODERN ELECTRONIS. WORKS WITH POINTS, ELECTRONIC OR MSD IGNITIONS

THIS UNIT WILL REPLACE EITHER A FACTORY TIC TOC TAC OR CLOCK. HOOKS TO FACTORY WIRING AND HAS MODERN MORE ACCURATE ELECTRONICS.

THIS IS A LITTLE SQUARE TAC THAT FITS ALL THE OTHER B-BODY INSTR.CLUSTERS FROM 68-70. FITS GTX'S, ROADRUNNERS,CORONETS ETC. HAS MODERN ELECTRONICS AND HOOKS TO FACTORY WIRING.

THIS IS A REPLACEMENT TAC UNIT FOR ALL 1970-74 MOPAR E BODIES WITH RALLEY INSTR. CLUSTERS.

THIS IS A TACHOMETER FOR ALL THOSE E BODY MOPARS WITHG OUT RALLEY CLUSTERS. BOLTS IN THAT BLANK SPOT ON THE FAR RIGHT AND HAS EASY HOOK UP INSTRUCTIONS

THIS IS A RALLEY TAC FOR 1967-71 A BODY MOPARS. IT HOOKS UP EASY IS VERY ACCURATE.THIS UNIT SWEEPS FROM BOTTOM RIGHT TO THE LEFT. see cs161 for other model.

THIS IS FOR 1967-71 A BODIES WITH RALLEY CLUSTER. FITS IN THE CENTER HOLE AND SWEEPS FROM BOTTOM LEFT OVER THE TOP.

THIS IS A REPRODUTION TAC HOOK UP HARNESS.IT HAS ALL THE CORRECT CONNECTORS TO MAKE THAT TAC INSTALL A SNAP.

THIS IS AN ISNTALLATION HARNESS FOR ALL 71-74 B-BODY TACS. IT HAS ALL THE CONNECTORS FOR A FACTORY LOOK AND EASY INSTALLATION.

THIS IS A REPRODUCTION CLOCK RESET KNOB FOR ALL 68-70 B-BODY TIC TOC TACS AND REG CLOCKS.(nut is included.)

THESE ARE REPRODUCTION HOOD SIGNAL LENSES FOR 68 &69 CHARGERS. SOLD IN PAIRS.

THESE ARE REPRODUCTION HOOD SIGNAL ASSEMBLIES FOR ALL 68 & 69 CHARGERS . SOLD IN PAIRS

THESE ARE REPRODUCTION HOOD SIGNAL LENSES. FOR 1970 CHARGERS.

THESE ARE REPRODUCTION HOOD SIGNAL ASSEMBLIES FOR 1970 CHARGERS. SOLD IN PAIRS

THESE ARE REPRODUCTION TAIL LIGHT LENSES FOR 1968 CHARGERS. SOLD IN SETS OF 4

THIS IS A REPRODUCTION PRIMERY HOOK UP WIRE FOR 68-70 CHARGERS. COMES WITH 3 CLIPS

THESE ARE REPRODUCTION 68 CHARGER REVERSE LIGHT LENSES. SOLD INDIVIDUALLY. (GASKET INCLUDED)

THIS IS A REPPRODUCTION REAR DECK FILLER PAN FOR ALL 68-70 CHARGERS.USED USUALLY WITH SAILPANELS FOR REAR WINDOW RUST REPAIR.

THESE ARE RUST REPAIR SAIL PANELS FOR BOTH SIDES OF THE REAR WINDOW . USUALLY USED WITH THE DECK PAN. SOLD IN PAIRS

THESE ARE VALANCE END CAPS FOR ALL 68-70 CHARGERS.SOLD IN PAIRS.

THESE ARE 68-70 CHARGER BUMPER SUPPORTS. THESE WELD TO THE TRUNK FLOOR AND BUMPER BRACKET BOLTS GO THROUGH THEM. SOLD IN PAIRS.

THESE ARE REPRODUCTION 69 & 70 CHARGER TAILLIGHT ELNSE GASKETS. SOLD IN PAIRS

THIS IS A REPRODUCTION SIDE MARKER HOUSING FOR ALL 69 A BODY , B BODY AND SOME C BODIES. SOLD IN PAIRS

THESE ARE REPRODUCTION 1969 MOPAR SIDE MARKER LENSES, SOLD IN SETS OF 4 (2 AMBLER & 2 RED )

1969 SIDE MARKER HOUSING GASKETS.SOLD IN SETS OF 4.

1971 & 72 CHARGER FENDER SIGNAL GASKETS. SOLD IN A PAIR..

1969 & 70 CHARGER REVERSE LIGHT LENSE GASKETS. ALSO FIT 69 ROADRUNNER. SOLD IN SETS OF 2

1969&70 CHARGER REVERSE LIGHT HOUSING TO BODY GASKETS. ALSO WILL FIT PLYMOUTH ROAD RUNNER. SOLD IN PAIRS

1969&70 CHARGER REVERSE LIGHT LENSE. ALSO FITS 69 ROADRUNNER.

1969 & 70 CHARGER REVERSE LIGHT LENSE RETAINER.ALSO FITS 69 ROADRUNNER. STAINLESS STEEL REPRODUCTION. SOLD IN PAIRS.

1969 & 70 DODGE CHARGER REVERSE LIGHT ASSY'S. PLYMOUTH VERSION COMING SOON. SOLD IN PAIRS

1968 & 69 CHARGER FRT PARK LAMP LENSES. SOLD IN PAIRS

1968 & 69 CHARGER PARKLAMP LENSE GASKETS. SOLD IN PAIRS

1968-71 CHARGER UPPER DOOR PAD MEDALLION INSERTS. SOLD IN PAIRS.

1968 & UP INTERIOR DOME LAMP LENSE.

Ballast resistor for 57-72 mopar ignitions

FITS MOST A B OR C BODY MOPARS. PENTASTAR LOCATED ON LOWER RIGHT FRONT FENDER

NEW WASHER BOTTLE FITS 68-70 B-BODY CARS .

DOME LENSE FITS SOME C BODY 1965&66 ALL B-BODY 1965-66

REPRODUCTION 68-70 B-BODY DASH VENTS. PAINTABLE. SOLD IN PAIRS WITH NUTS.

REPRO LOCK PUSH BUTTONS FOR 1964-74 A/B/C BODY EXCEPT E.

REPRO LOCK PUSH BUTTONS FOR ALL 1964-74 A/B/C BODIES EXCEPT E

RUBBER SEAT BELT MOUNT COVERS FOR THE DIVE SHAFT TUNNEL 1967-70 A & B BODY. SOLD IN PAIRS.

NEW GAS PEDAL AND MOUNTING HARDWARE FOR 1971 & 1972 A/B/C BODY CARS.

FITS MOST A B & C BODIES . SEAT RAIL PADS .SET OF 4.

FITS MOST 66-70 AUTO TRANS FLOOR SHIFTERS. REPLACES 2 LOWER PIVOT BUSHINGS AND SHIFTER ROD BUSHING.

13" METAL REINFORCED ARMRESTS FOR CHARGERS AND OTHER MODELS.SOLD IN PAIRS

13" METAL REINFORCED WHITE ARMRESTS. THESE ARE DYE-ABLE AND ARE SOLD IN PAIRS.

1968-1970 CHARGER ONLY HOOD BUMPER KIT.

FITS 71 &72 B-BODY AND 73-74 SATTELITE, INCLUDES WEDGES AND SCREWS.

1969 A/B/SOME C BODY SIDE MARLER RETAINERS . SOLD INDVIDUALLY

SET INCLUDES, 4 housings, 4 gaskets,8 nuts, 4 retainers and 4 lenses.

2 PRONG BALLAST WIRE TERMINAL COVER. FOR ALL WITH DUAL BALLAST IGNITION

FOR 1969 AND LOWER CARS. ENGINE HARNESS TERMINAL, HOLDS 8 WIRES

WHITE ENGINE WIRE TERMINAL COVER FOR 70 & UP E BODY , 71 & UP B BODY, HOLDS 8 WIRES

WHITE WIPER TERMINAL COVER FOR 70 & UP E BODY ,71 & UP B BODY

5/8" DIAMETER HOLDER (TWIST LOC) FOR DASH BULBS. FITS SEVERAL YEARS AND BODIES. EA.

PUSH IN 1/2" DAIMETER BULB HOLDER FOR INSTRUMENT CLUSTER AND OTHER LOCATIONS ( use with 157 tac.)

FEMALE TERMINAL COVER FOR SINGLE WIRE APPLICATION. EA..

TERMINAL COVER FOR MALE CONNECTORS. SINGLE WIRE APPLICATIONS

FEMALE WIRE TERIMINAL END. HIGH QUALITY BRASS

HIGH QUALITY BRASS MALE WIRE TERMINAL EA.

90 DEGREE PUSH ON CONNECTORS FOR DASH GUAGE WIRING REPAIRS. EA.

1972 & UP A/B/SOME C BODY SIDE MARKER BULB SOCKET. HAS 2 WIRES FOR PUSH IN BULBS. EA.

SEAT BELT CLIPS FOR 68&69 A OR B BODY W/ BUCKET SEATS. BLACK OR WHITE. (PAINTABLE) SET

FITS 68 OR 69 A & B BODY WITH BENCH SEATS. BLACK OR WHITE (PAINTABLE) SET

FITS 68 & 69 A OR B BODY WITH BENCH SEATS. BLACK OR WHITE (PAINTABLE) PR.

FITS 68 & 69 A OR B BODY. 2DR HDTOP OR CONV. BLACK OR WHITE (PIANTABLE( PR.

SEAT HINGE COVER FOR 72-74 E BODY & 71 & UP B BODY B W/ BUCKET SEATS. BLACK OR WHITE (PAINTABLE)

FITS 1970-72 A-BODY BODY W/ BENCH SEATS. BLACK OR WHITE (PAINTABLE) PR.

ENGINE TO FIREWALL GROUND STRAP FOR 1963-69 BIG BLK NON A/C CARS

1963-69 BIG BLK WITH A/C AND OR HEMI. 10" LONG

FITS ALL SML BLK 1963-69 ENGINE TO FIRE WALL. 16" LONG

FITS 1966-69 BIG BLOCK APPLICATIONS

1968-70 CHARGER DASH VENTS AND HOSES

1968 -70 B BODY EXCEPT CHARGER DOOR LOCK FERRELS . PAIR

1968-70 CHARGER DOOR LOCK FERRELS.PR.

FITS 1969-70 B-BODY, 1970 E BODY, 1969-74 A BODY. INCLUDES KNOB, SPRING AND BUTTON

WINDOW CRANK HANDLES FOR A/B/C/E BODY CARS, WASHERS NOT INCLUDED. SOLD IN PAIRS.

1968-70 CHARGER , CORONET, BEE, 70-74 CHALLNEGER, 67-72 DART, 68&69 CUDA,65-67 GTX

FITD 64-67 CUDA, 66&67 CHARGER, 68-70 ROADRUNNER,71-74 CHARGER

FITS 1972 B BODY

FITS 73+74 E BODY, 1970-74 B BODY INCLUDES BOTTLE ,HOSES CAP AND CLAMPS

1969 PLYMOUTH PARK LAMP LENSE FOR SATTELITE & ROAD RUNNER PER PAIR

1970 PLYMOUTH A &B BODY MARKER LIGHT LENSE SET OF 4

COMPLETE PARK LAMP ASSEMBLIES FOR 68 & 69 CHARGERS. INCLUDES LENSES,HOUSINGS WITH WIRE , BULBS AND GASKETS. PRICE PER PAIR

ELECTRIC HEADLAMP COVER MOTOR RELAY FOR 70 & UP CHARGERS , PLYMOUTHS AND CHRYSLERS

THESE ARE THE MEDALLION THAT IS ON THE UPPER DOOR PAD ON ALL 68-70 CHARGERS AND SOME 71'S

Dash dimmer control for 68-70 chargers

VACUUM CONTROL SWITCH FOR 68 &69 CHARGER VACUUM CONTROLLED HEADLIGHT DOORS

IN DASH TACH FOR 1964 PLYMOUTH FURY & SPORT FURY

vacuum hose kit for headlamp cover operation on 68-69 chargers

1973-74 B body doge and plymouth washer bottle . includes pump and cap.

New lectric washer pump. for all electric resviors

vacuum cannister for headlamp cover operation on 68-69 chargers

in dash tachometer for 1971-74 B-body cars , Chargers, Roadrunners etc.

Window washer squirters for 67-70 b-body cars

New cap for washer reservoirs

new cap for coolant over flow bottles